Jane.doe: Created page with "'''SET HOST''' is a DCL command that connects your terminal (through the current host processor) to another processor, called the remote processor..."

2019-12-03T12:55:40Z

Created page with "'''SET HOST''' is a DCL command that connects your terminal (through the current host processor) to another processor, called the remote processor..."

New page

'''SET HOST''' is a [[DCL]] [[Command|command]] that connects your [[Terminal|terminal]] (through the current host processor) to another processor, called the remote processor. The command requires that:
* You must have an account on the remote system to log in.
* The [[NETMBX]] (network mailbox) privilege is set.
=Syntax=
SET HOST node-name
==Qualifiers==
* /APPLICATION_PROTOCOL
* /BUFFER_SIZE
* /LOG
* /MOP
* /RESTORE
* /DTE connects your system to a remote system through an outgoing terminal line
* /DUP connects your terminal to a storage controller through the appropriate bus for that controller.
* /HSC connects your terminal to an HSC disk and tape controller through the computer interconnect (CI) bus.
* /LAT connects your terminal to a specified service available on the local area network (LAN).
* /RLOGIN allows you to log in to a remote host over a TCP/IP connection and start an interactive terminal session by accessing the RLOGIN application.
* /TELNET connects you to a remote host over a TCP/IP connection by invoking the TELNET application.
* /TN3270 connects you to a remote IBM host over a TCP/IP connection, causing the local keyboard to emulate an IBM 3279-class terminal keyboard by invoking the TN3270 terminal emulator.
[[Category:DCL Commands]]

SET HOST - Revision history

Jane.doe: Created page with "'''SET HOST''' is a DCL command that connects your terminal (through the current host processor) to another processor, called the remote processor..."