FAST PATH PORTS
Revision as of 06:07, 9 April 2019 by Darya.zelenina (talk | contribs) (Created page with "'''FAST_PATH_PORTS''' is a static system parameter that deactivates Fast Path for specific drivers on Alpha and Integrity servers. FAST_PATH_POR...")
FAST_PATH_PORTS is a static system parameter that deactivates Fast Path for specific drivers on Alpha and Integrity servers.
FAST_PATH_PORTS is a 32-bit mask, with a bit assigned for each Fast Path port driver:
| Bit value | Description |
|---|---|
| 1 | Indicates that Fast Path is disabled for ports serviced by the corresponding driver. |
| 0 | Indicates that Fast Path is not disabled for ports serviced by the corresponding driver. |
Beginning in OpenVMS Version 7.3-1, values of specific bit positions are those described in the following table:
| Bit position | Description |
|---|---|
| 0 | Controls Fast Path for PKQDRIVER (for parallel SCSI). |
| 1 | Controls Fast Path for FGEDRIVER (for Emulex LP7000, LP8000, LP9002, LP9802, LP10000 FibreChannel). |
| 2 | Controls Fast Path for PKADRIVER (for Adaptec AIC-78xx Ultra3 SCSI). |
| 3 | Controls Fast Path for PEDRIVER (for LAN). |
| 4 | Controls Fast Path for PKRDRIVER (for SMART Array 5300). |
| 5 | Controls Fast Path for PKMDRIVER, the LSI Logic LSI53C1030 SCSI port driver. |
| 6 | Controls Fast Path for PGQDRIVER, the Qlogic ISP23xx FibreChannel port driver. |
Currently, the default setting for FAST_PATH_PORTS is 0, which means that Fast Path is enabled for all drivers that appear in the table.
In addition, note the following:
- CI drivers are not controlled by FAST_PATH_PORTS. Fast Path for CI is enabled and disabled exclusively by the FAST_PATH system parameter.
- FAST_PATH_PORTS is relevant only if the FAST_PATH system parameter is enabled (equal to 1). Setting FAST_PATH to zero has the same effect as setting all the bits in FAST_PATH_PORTS to 1.
