... working set quota extent ( WSEXTENT ) on a system that has a substantial memory on the free-page list. This automatic working set adjustment also ...
867 bytes (130 words) - 19:31, 4 June 2019
... (suspended) processes, DORMANT processes are the most likely candidates for memory reclamation by the swapper. Increasing the value of DORMANTWAIT can ...
818 bytes (122 words) - 05:31, 9 April 2019
... (1) or disables (0) the writing of error log buffers and memory contents to SYS$SYSTEM: SYSDUMP.DMP when a fatal bugcheck occurs. This parameter ...
313 bytes (45 words) - 05:36, 9 April 2019
... System Parameters system parameter that specifies the amount of S0 space memory to allocate for each S0 space error log buffer requested by ...
284 bytes (38 words) - 05:48, 9 April 2019
... System Parameters system parameter that specifies the amount of S2 space memory to allocate for each S2 space error log buffer requested by ...
454 bytes (70 words) - 05:49, 9 April 2019
... are either reserved for future use, or given back to the free memory list. GH_RES_DATA has the AUTOGEN and FEEDBACK attributes. Category:System ...
541 bytes (89 words) - 06:32, 9 April 2019
... are either reserved for future use, or given back to the free memory list. GH_RSRVPGCNT specifies the number of pages that LDR$WRAPUP attempts to ...
864 bytes (142 words) - 06:33, 9 April 2019
... advantage of architectural features such as byte and word memory reference instructions, and floating-point improvements, which are available only ...
2 KB (349 words) - 07:00, 9 April 2019
... New system parameters ERLBUFFERPAG_S2 specifies the amount of S2 space memory to allocate for each S2 space error log buffer. ERRORLOGBUFF_S2 ...
10 KB (1,482 words) - 08:05, 2 December 2019
... affected because IRPCOUNTV cannot be used for nonpaged pool requests. A physical memory penalty of 1 percent results for any unused growth space (1 ...
466 bytes (66 words) - 09:12, 9 April 2019
... Parameters system parameter that defines the maximum amount of physical memory, measured in pagelets, that can be associated with a single buffer ...
392 bytes (60 words) - 09:40, 9 April 2019
... system parameter reserved for VSI use. Its value must be the same on all nodes connected by MEMORY CHANNEL. Category:System Parameters
195 bytes (31 words) - 09:48, 9 April 2019
... that this value not be changed. This parameter value must be the same on all nodes connected by MEMORY CHANNEL. Category:System Parameters
368 bytes (57 words) - 09:49, 9 April 2019
... that this value not be changed. This parameter value must be the same on all nodes connected by MEMORY CHANNEL. Category:System Parameters
363 bytes (56 words) - 09:50, 9 April 2019
... and must remain at the default value of 8000000. This value must be the same on all nodes connected by MEMORY CHANNEL. Category:System Parameters
249 bytes (40 words) - 09:50, 9 April 2019
... only and must remain at the default value of 0. The value must be the same on all nodes connected by MEMORY CHANNEL. Category:System Parameters
234 bytes (39 words) - 09:54, 9 April 2019
... of the modified-page list is reduced. If it is too high, less memory is available for processes, so that swap (and page) may increase. MPW ...
603 bytes (101 words) - 11:16, 9 April 2019
... MPW_LOWAITLIMIT increases system performance for fast processors with large memories by reducing the amount of time processes spend in the MPWBUSY ...
424 bytes (60 words) - 11:19, 9 April 2019
... default value is currently 32. Unless a system has very constrained memory available, VSI recommends that these values not be increased. Category ...
333 bytes (49 words) - 11:31, 9 April 2019
... File page file Inswap Rate: rate at which working sets were read into memory from the Swap file swap file Free List Size: number of pages on ...
1 KB (227 words) - 11:22, 2 June 2019
... The size of the swap files can be displayed with '''SHOW MEMORY/FILES'''. =Calculating Swap File Size= AUTOGEN calculates an appropriate size for ...
4 KB (706 words) - 04:55, 8 June 2019
... exists in the rights database. - SS$_INSFMEM The process dynamic memory is insufficient for opening the rights database. - SS$_IVIDENT The ...
5 KB (698 words) - 12:23, 15 July 2019
... = "7AE42000" - FREPTECNT Number of pages available for virtual memory expansion. $ a = f$getjpi("","FREPTECNT") $ show sym a A = 2147483647 Hex ...
22 KB (3,044 words) - 17:48, 28 June 2019
... channels to non-shared devices SHMEM may create/delete objects in shared memory SYSGBL may create system wide global sections SYSLCK may lock system ...
7 KB (876 words) - 13:49, 14 December 2021
... system parameters. This calculated value is based on the amount of physical memory in the system. NPAGECALC's calculations do not reduce the values of ...
867 bytes (126 words) - 11:28, 29 June 2019
... use for NPAGERAD with the following formula: NPAGERAD = NPAGEDYN (1-(Base RAD memory/Total memory)) This calculation gives more pool to the non-base ...
2 KB (277 words) - 11:36, 29 June 2019
... the bus addressable pool (BAP) that the system creates when memory resources are unusually constrained. It is available on Alpha and Integrity ...
290 bytes (43 words) - 13:49, 29 June 2019
... The initial value is expanded during system operation, if needed. Memory Channel devices ignore this parameter. PASTDGBUF is an AUTOGEN parameter. ...
347 bytes (46 words) - 14:24, 29 June 2019
... setting has been raised to accommodate the increased demands for process-permanent memory that result from changes made to RMS file-naming parsing in ...
769 bytes (120 words) - 14:53, 29 June 2019
... sections in any section to be run, as indicated by the linkage memory allocation map for the image. PROCSECTCNT has the AUTOGEN and GEN attributes. ...
453 bytes (70 words) - 06:23, 30 June 2019
... number of resources in use on the system. Managers of systems with memory constraints or systems that are not critically dependent on locking speed ...
549 bytes (85 words) - 06:25, 30 June 2019
... , a larger number that allows some of the index buckets to remain in memory can improve performance. You can set this system parameter with the DCL ...
571 bytes (89 words) - 16:52, 30 June 2019
... aspects of SYS$PBDRIVER , the OpenVMS Galaxy Galaxy SMCI Shared Memory Cluster Interconnect (SMCI) . It is available on alpha OpenVMS ...
1 KB (154 words) - 08:26, 2 July 2019
... serving of local tapes. Setting TMSCP to 1 loads the tape server into memory at the time the system is booted and makes all directly connected tape ...
908 bytes (141 words) - 15:40, 2 July 2019
... your system that is close to the number specified. If insufficient memory is available during system startup, OpenVMS might choose a smaller size for ...
1 KB (193 words) - 15:57, 2 July 2019
... Because the VIRTUALPAGECNT setting supports hardware address space rather than system memory, do not use the value of VIRTUALPAGECNT that AUTOGEN sets ...
1 KB (208 words) - 16:12, 2 July 2019
A '''page''' is a unit of memory allocation in OpenVMS. For VAX , a page is equal to a Block block , 512 Byte bytes . For Alpha , page ...
504 bytes (74 words) - 00:15, 15 December 2019
A '''pagelet''' is a unit of memory equal to 512 bytes (like a VAX Page page ). =See also= Page
109 bytes (18 words) - 05:46, 3 July 2019
'''Primary page cache''' is the region of physical memory where the processes' working sets reside and processes execute also called the Working Set ...
165 bytes (25 words) - 05:58, 3 July 2019
'''Secondary page cache''' is the region of Physical Memory physical memory where data is stored for movement to and from the disks. Sections of ...
386 bytes (57 words) - 06:01, 3 July 2019
... new context should be established. Because an active context block consumes process memory, be sure to release the context block by setting the RELCTX ...
13 KB (2,135 words) - 10:47, 3 February 2020
... argument was missing. - SS$_INSFMEM There was insufficient system dynamic memory for the operation. - SS$_NOCURTID The calling process did ...
2 KB (297 words) - 12:48, 28 November 2019
... argument was missing. - SS$_INSFMEM There was insufficient system dynamic memory for the operation. - SS$_NOCURTID An attempt was made to ...
12 KB (1,841 words) - 15:11, 15 July 2019
... argument was missing. - SS$_INSFMEM There was insufficient system dynamic memory for the operation. - SS$_INVBUFLEN The string passed in the ...
20 KB (3,140 words) - 12:45, 28 November 2019
... allows a porcess to create global sections and Mailbox mailboxes in memory shared by multiple processors if the process also has appropriate ...
1 KB (191 words) - 11:19, 2 December 2019
... clusters are not explicitly deleted, they tie up space in system dynamic memory, which may degrade system performance. Category:Devour Privileges
597 bytes (85 words) - 16:30, 23 July 2019
... version of the operating system. - SS$_INSFMEM The system dynamic memory is insufficient for completing the operation. - SS$_NONEXPR The ...
6 KB (972 words) - 12:46, 28 November 2019
... version of the operating system. - SS$_INSFMEM The system dynamic memory is insufficient for the operation. - SS$_IVLOGNAM The process name ...
5 KB (883 words) - 07:48, 14 November 2019
... to the first process. =Value Block= A '''value block''' is a 16-byte piece of memory associated with each resource that holds the current lock mode ...
14 KB (2,289 words) - 06:40, 16 November 2019
... - OpenVMS-RMS-DecBasic-Macro64 Try to create a OpenVMS project from memory using RMS-FDL-DECBasic on a OpenVMS system. (notes) Jason ...
28 KB (4,116 words) - 11:35, 19 October 2021
